The Beta65S Lite drone is ready to fly and the Silverware firmware does not require switch setting like Betaflight does. Just bind to your radio transmitter, select the mode you want and enjoy it. This manual is also effective for BETAFPV Lite FC board.


Bind Radio Transmitter

Pluging in a battery and waiting for about 4 seconds, the drone will enter binding status. It is indicated by the LEDs flash stably and slowly.


TX01 Transmitter

Power on the TX01 radio transmitter. Move the trottle stick up and down quickly. Binding procedure finish. If binding successfully, the LEDs on the drone will be solid on.


Jumper T8SG Transmitter

Power on the T8SG transmitter. Main menu -> Model menu -> Model setup. The select the protocol "Bayang" and enter Re-Init. If binding successfully, the LEDs on the drone will be solid on.


MTX-9D Module


Slow & Fast Change

In every mode (acro or level), there are 2 speed choices. One is slow and the other is fast. By default, we use the channel 9 on the radio transmitter to switch it.


Guestures

By default, certain stick sequences, which we call gestures, are used to activate some features, or issue commands. For example, the gesture Down - Down - Down would be accomplished by moving the pitch stick down 3 times in a short time.

1) Change Mode

  • Left - Left - Down: acro mode
  • Right - Right - Down : level mode

2) Change PID

First, you should select the value you want to change.

  • Up - Down - Up: Cycle pid term to the next ( P - I - D )
  • Up - Down - Down: Cycle pid axis to be changed ( Roll/Pitch - Yaw )

Second, you could decrease or increase the selected value.

  • Up - Down - Left: Decrease the selected value
  • Up - Down - Right: Increase the selected value

Finally, save the changed PID value.

  • Down - Down - Down: Accelerometer calibration / Save pids if changed


3) Calibrate Accelermeter

  • Down - Down - Down: Accelerometer calibration / Save pids if changed